anyone have a wagoneer?

[scout man]

Looking for the measurement and maybe a picture of a grand wagoneer pitman arm. Anyone here have access to one, or can measure at a junkyard for me?

[Fordguy77]

There's one parked on the street behind me. I might go try and snag a pic and measurment for you. Just lookin for length? Or pin dia or what?

Sent from my T-Mobile myTouch 3G Slide using Tapatalk

[scout man]

Mainly looking for length. Amount of drop could be good too. Thanks!

[glacierpaul]

I have 2, J-20's may be the same. But here you go...http://fsjjeepparts.com/

[scout man]

from what I can tell that give me a place to buy one, but not the measurements of it. I dont know for sure yet if it will do what I need it to do.

[glacierpaul]

I can measure each on both of my J-20's if you'd like Steve. I thought that site had the spec's, must be another one.

[Brody]

This guy is really good, so you may find what you need there, too:

http://www.partsmike.com/

Couldn't find measurements..

[scout man]

Are those j20s the same front end as the wagoneer? A measurement would be great. I know the wagoneer has the right splines, so I would that yours would too most likely.

[glacierpaul]

The chassis should be the same, but AMC did a lot of crazy sh*t back in the day. I will get a measurement w/pic from both, and post up later Steve.

[scout man]

thanks a lot!

[Fordguy77]

thanks a lot!

On my way to my neighbors should have it soon for you.