Shane
June 19th, 2013, 01:43 PM
I needed to replace the rear axle seals on the jeep took the axles down to napa for them to replace the seals and bearings was on a time crunch (so could not go to anyones house if they had one) having to use my vehicle while the work van is in the shop. the question i have is should they have replace the bolt plate on the axle shafts?. I could not remember the torque spec for the nuts so I went and googled it 45ftlbs. It also stated that you should not reuse the plate and nuts. So because I had to go to work I threw some red lock tight on the treads. Does anyone think that this may cause and issue later?