Anyone have a Dwell Meter

[Cr33p3r]

Does anyone have one I could use for a day, I need to set up the carb for fuel mixture and lower RPM. That is the part of the E test the Bronco failed on (HC and idle) both were a tad high. I have 10 days to redo the E test.

[carpenle]

I have not used it in awhile but I have one like this http://www.ebay.com/itm/Reduced-price-Dwell-points-and-RPM-meter-/271389247838#ht_227wt_920

[Cr33p3r]

That would work, When can I get with you Levi? I gave mine away a few years back I think cause I thought I would never have a use for one again DUH!

[carpenle]

I will pull it out of the tool box tonight. I should be home after 6 tonight, so it depends on your schedule. I am off 124th and Colorado. I will PM my cell #.

[Jim]

If needed, I believe I still have one or two about. I _might_ be heading to Denver this weekend.

[Hypoid]

I gave mine away a few years back I think cause I thought I would never have a use for one again DUH!Still have it. :) If you can't get with Levi, I can run it up after dinner. Do you need a timing light, vacuum gauge?

[otisdog]

I have one and a timing light. Southeast Aurora.
Jim

[carpenle]

Pulled it out of the tool box and it is ready whenever you are.

[The StRanger]

The one I used to use back in the day (The 90s)
Was the big AllenTest. You know that big thing that hung of an I beam !
I think it was AllenTest ??

[Tom]

I have one and a timing light. Southeast Aurora.
JimMe too though they're cheap ones and from the early
1980's

[Patrolman]

I have a couple of them, including one that does multiple voltages. It is in a suitcase sized box. I think it is 6, 12, 24, and 36v. Let me know if nothing else pans out.

[Cr33p3r]

Thanks guys, I have a timing light and vacuum gauge, I will be getting with Levi Friday hopefully.