Wrenching Sunday, Feb 15

[Myrtle Turtle]

Assuming the weather & UPS guy continue to be on track I will be doing some front end work on Sunday. The primary job is replacing my stock knuckles with Reid Racing HD ones. I also have new unit bearings and new TREs for all the parts that will be off. I plan to start removing parts on Saturday, so hopefully will be at the fun re-assemble part by Sunday morning.

We'll probably order pizza for lunch when done and adult beverages are available.
I don't usually have soft drinks, so you are on your own there.

We're in the far east end of Englewood, at Otero & Jordan.
Will start work between 9 & 10 am.
Helpers & spectators welcome, bathroom access does require being dog friendly.

PM or text for address - 214 326 thirteen thirteen

[Myrtle Turtle]

This is off. Work went MUCH faster than anticipated and I'm done already.

[RidgeRunner]

Well done!

[Jim]

Good deal!

Everything worked out as desired?

[Myrtle Turtle]

I need to flex it out and make sure I'm clearing the drag link on the driver side, but I had it flipped already so that should be good. This was more about getting the tie rod higher than anything, but I may end up raising the track bar a little, it was a little off the drag link line before, and it's off a little bit more now but I was able to do freeway speed on Sunday so I'm in no rush.

http://i1226.photobucket.com/albums/ee418/Q-Chaos/2013%20JKU/knuckleswap1_zps05156e8f.jpg

http://i1226.photobucket.com/albums/ee418/Q-Chaos/2013%20JKU/knuckleswap2_zpsa316abac.jpg