Anyone in the SE Metro have a press I can use?

[Spieg]

Looking for about 30 minute use of a hydraulic press. Doesn't need to be fancy, just needs enough space to fit a disk brake/wheel hub (about 14" across) so I can press in some wheel studs. Local machine shop wants too much $$ for such a simple job (I could almost buy a new press at Harbor Freight for what they're asking). Happy to kick in a few bux (or beer) for the trouble.

[Hypoid]

Wheel studs? I have used an extra nut, hardened washers, and an impact to install wheel studs.

[Spieg]

That's my usual technique but these are new hubs/studs and clearance is too tight. I managed to strip the threads off the first one (it was a PITA to cut it off after that so I don't want to try that again). Crown is not known for the best quality hub casting so the holes are probably a little smaller than they should be.

[Jim]

I have one of these if you wish to trek up...

https://shop.harborfreight.com/media/catalog/product/cache/1/image/9df78eab33525d08d6e5fb8d27136e95/i/m/image_25778.jpg

[Swank1975]

I have one of these if you wish to trek up...

https://shop.harborfreight.com/media/catalog/product/cache/1/image/9df78eab33525d08d6e5fb8d27136e95/i/m/image_25778.jpg


Hey I have that same press.

[dieseldoc]

We're have a12ton shop press.
Will be at the shop today.
And tomorrow.
As well you can hit me up for any afternoon after 330.

[Spieg]

Job is already finished , but thanks for the offer Brandon.

[dieseldoc]

Glad its done man.
Hit me up when you got things like this.
You would be amazed at what we have for tools!
My partner is a 4ton auto crain so go figure!