Chris' FJ Bumper

[Chris]

Pete's done some bumper work for me lately and since it's done I thought I's share. This started simply enough with me wanting to raise the front bumper a couple inches, no big deal though we found it took a whole lot longer than we expected. This was followed by the addition of some winch protection by adding a bar below the winch. Then, the cool part, was Pete building a 'ramp' or 'skid/skip' plate from the new bumper piece to the reversed shackles which hang a bit lower than desired. The plate is very well reinforced and I can't wait to see how it works when I get the chance.

[Pathrat]

That looks great and super-functional! I can't wait until I can get some fab work done on my rear bumper

[Brody]

Glad you are back Stephanie! Hope that you had a great time!

We still need to do a simple piece of plate for looks on the outside of the skip plates, but the functionality is there right now..

[1freaky1]

Looks good guys, I like the slider plates under it.

[Funrover]

Cool, looks like everyone is keeping Brody busy! Bumper looks good Chris

[Haku]

Brody Fab? Does that have anything to do with Booty Fab?

Looks great Chris. Should make getting up onto ledges a lot easier and I'm sure your shackle reverse, springs, and winch will be happier too.

JH

[brian pleasant]

sweet.. i need one for my f150 down at florida and that little yellow tj too

[Chris]

Pete finished them the other day, I'll have to get the camera out.