I’m at a loss here. Last weekend I had some folks help me install my Clayton 2.5” lift. It comes with an adjustable track bar which I set to the recommended length from Clayton. Long story short, the Jeep drove like crap, I thought I was going to die. I fixed the major I’m going to die issue by loosening and re-tightening the track bar under load. One other issue I found was the axle wasn’t centered, off about 1” driver. Anyway, I loosened EVERYTHING and removed the lower shock bolts and was able to adjust my track bar. After the adjustment, I was within 1/8” on each side. After tightening almost everything, somehow it seems it’s off about an inch again! Someone said I do NOT have to loosen and remove shock bolts to adjust the axle, I don’t understand how though. Does anyone know how to adjust the front axle on a Jeep without the hours of work loosening and removing bolts?